Stork Carbon Fiber Shaft for Minelab Equinox

Glides through the water like you have never experienced.
Light, strong and rigid
Only .40 pounds
Bolts (for maximum rigidity) directly to your Equinox 600 or 800 with the supplied Stainless screws, with our without the plastic knobs.
Included are colored knobs/screws which you might like. Yellow is a 6mm and screws the upper handle and the red is 1/4-20 for the mid shaft. Be sure not to mix up the screws: The finer thread 6mm screws for the upper connection and the 1/4 course thread for the mid section.
The lower tear drop shaped rubber washers are larger than the original Minelab. 2 spare washers are supplied incase you wear the original set out in a year or two.
You should use your original coil screw and nut but we have included a spare nylon screw and wing nut just incase.
Carbon Fiber Mid and Lower shaft
A premium roll of 3M black tape is included so you can seal all holes and joints so sand will not enter and freeze up your shafts.
The Mid shaft is 3/4" diameter, smaller than the 20mm original
The lower shaft is 10mm diameter (just over 3/8")
We provide a 3 year warranty if you seal all holes and joints with black electrical tape (supplied) so sand will stay out of the joints.
MADE IN THE USA

Stork Carbon Fiber Shaft for Minelab Equinox Metal Detector